Mitsubishi MUT-3 Car and Truck Diagnostic Tool Kit / Mitsubishi MUT III Adapter With Coding Options – Software Installation Included !

Set Includes:

1. Vehicle Communication Interface (V. C. I. ) (MB991824)
A communication interface used to connect the vehicle ECUs and the PC.

1). When connected with the PC
– Vehicle diagnosis (Interactive fault diagnosis)
– SWS communication; CAN communication support
– Drive recorder
– ECU reprogramming
– Volt, Ohm, measurement
– Fuel pressure measurement (Not available in US)

2). When used with the V. C. I. Unit (disconnected from PC)
– V. C. I. Stand-alone diagnosis
– Drive recorder
– ECU reprogramming
– Volt, Ohm measurement
– Belt Tension measurement
(MB991939).

2. MUT-III Main Harness A (MB991910)
Used when connecting the V. C. I. with vehicles that have
Only one 16-pin diagnosis connector.
– Supports fault diagnosis and ECU updating on the
Above-described vehicles
– Supports the CAN communication system

3. MUT -III Main Harness B (MB991911)
Used when connecting V. C. I. with vehicles that have a 16-pin + 12-pin or 16-pin + 13-pin diagnosis connector.
For models equipped with only 12-pin (or 12-pin + 12-pin) Diagnosis connector, connect the M. U. T. -II adapter harness (MB991498) to the end of this harness in the same as M. U. T. -II, and power is supplied from the cigarette lighter  Socket.